ADEMCO Alpha Vista Console Manual de Instruções Página 20

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 68
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 19
Note:
A special
“trim ring
t?has been supplied for installation between
the wall and the console for those cases where the opening has
inadvertently been made too large
(over-cutting).
The console
fits into the recess in the trim ring which will extend 1/2” (1.3
cm) beyond the console front panel,
and thus cover any opening
that might otherwise be visible as a result of over-cutting.
2.
Remove the back cover on the console.
The securing screw at the front of
the console must be removed to release the back cover (see Diagram 4 for
screw location).
Discard the back cover, but retain the screw.
3.
Pull the interface wiring in the wall through the opening prwiously made.
Splice the appropriate wires to the console wires (or to the wires on the
interface connector supplied with later production 4137s).
See Diagram 1
and Table C for wire colors and assignments.
Note that the Blue wire on
the console may not necessarily be used.
Insulated solderless wire splices
(such as Ademco No.
311) may be used for splicing. Check all wire
connections carefully before splicing.
4.
If a late production 4137 is being used,
attach the interface connector to
the board at the rear of the console.
INSERT NAMEPLATE
INTO RECESSED
AREA (COVERS SCREWI
‘7
.
\
/
\
)
>
>
\
SECURING
SCREW
Diagram 4. INSERTING NAMEPLATE
Refer to Diagram 6 for Steps 5. 6 and 7:
5.
Mount the console as follows. Insert securing screw (previously renoved) in
screw hole at front of console (see Diagram 4) and attach metal clip (at
the rear) as shown in Diagram 6.
Turn the screw until the clip enters the
cylindrical plastic guide point about 1/8 of an inch (3 mm).
6.
Insert the straight end of the flat spring into the slot at the other side
of the console, as shown.
20
Vista de página 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 67 68

Comentários a estes Manuais

Sem comentários