ADEMCO 4140XMPT2 Manual de Instalação descarregar pdf (Página 18)

CHECKING FOR OPEN ZONES

thing the ❑ READY Before arming your system! alI protected doors! WindOWSand other protection zones

must be closed or bypassed (see BYPASSING section). Otherwise the console ~

‘ey will display a

“Not Ready” message.

If the Not Ready message is displayed prior to arming, pressing

the READY key

?xw#6iPg#ti8/&&#f~# j!;

will display all zones that are faulted, making it easier for you to secure any open

?$@&tii@&a$Ri%!m:m !

zones

%%@&$$w$ti+:%%w@?%;;,

~$~#f~&&**fwtiAt4*ffi,

o show faulted zones, simply press and release the READY key (do not enter

‘?M,*;~*wtii~,~;*#Otietiihs:

~de first)”secure or bYP=s the zones disPlaYed before =mif19 the sYstef-11’

%!#mMi%iq4M4;::fh4ffti:6:{

The “Ready” message

will be displayed when all protection zones have been

‘i;%;%!w.~:wwwmm 3:

either closed or bypassed.

:;:~~~$iw!~:w;?i$wqqi;

Displaying All Zone The Alpha Consoles can also display all the zone descriptors that are programmed

Descriptors in your system by pressing the READY

key and holding down for at least 5

seconds*. The abbreviated instructions for the READY key will appear first,

followed by the descriptors programmed for your system. Displaying all descriptors

is useful when you need to know the zone number of a particular zone, as when

bypassing zones.

* Note that the “Disarmed-Ready to arm” message must be displayed before zone

descriptors can be displayed.

@Jtim

TYPICAL CONSOLE KEYPAD

q m“ m ‘ ~:~j,

,“,~~~~~:,,$ ‘&R”DyK”

-18-

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 53 54

Sem comentários

ADEMCO 4140XMPT2 Manual de Instalação Página 18