ADEMCO LYNX Manual do Utilizador

/<1;/<1;56HFXULW\6\VWHP3URJUDPPLQJ)RUP6XPPDU\RI&RQQHFWLRQVN8890V2 6/99®

- 10 --%ztSTOP ZONE TYPE (if applicable)Enter the 2-digit stop zone type for the device being programmed ( see Powerline Carrier DeviceWorksheet for

- 11 --bzz-bSERIAL NUMBEREnter the transmitter’s 7-digit serial number (printed on the transmitter). If an incorrect digit is entered,press the [#] k

- 12 -*85 RECORD CUSTOM VOICE DESCRIPTORSUse this mode to record up to 5 custom voice descriptors for use with zone announcements. Press *85 while in

- 13 -Zone No. Zone Alarm Report Input Loop Transmitter Vocabulary(A 01) Type (zt) Code in hex (rc) Type (I) No. (l) Serial Number Index 1|9 |

- 14 -l = LOOP NUMBER Used with 5800 RF Loop Input Devices. Record transmitter loop number.Entries are 1-4, depending on device being used. Refer t

- 15 -Note: In normal operation mode:For Devices 1-6: For Devices 7 and 8: N = device (unit) numberFunction + Lights On + N Code + Function + 4 + N (

BELL6-14VDC120mA max.(e.g., WAVE2EX)HANDSETPHONELINE}INCOMINGPHONELINE}EARTH GROUND2k OHMSEOLRINCOMINGPHONELINETO HANDSETPHONELINEPIEZO6-14VDC30mA max

- 2 -7$%/(2)&217(176DATA FIELDS...

- 3 -/<1;/<1 ;5DATA FIELDSField Function Programmed Values [ ] = Table 1 Default ValuesSYSTEM SETUP (✱ 20– ✱ 30)✱20INSTALLER CODE

- 4 -Field Function Programmed Values [ ] = Table 1 Default Value✱34EXIT DELAY | †[70]00-99 = exit delay time (in seconds).UL installations

- 5 -Field Function Programmed Values [ ] = Table 1 Default Value✱43PRIMARY SUBS ACCT # See note on previous page✱44SECONDARY S

- 6 -TO PROGRAM SYSTEM STATUS, & RESTORE REPORT CODES (✱59–✱76, & ✱89):With a 3+1 or 4+1 Standard Format: Enter a code in the first box: 1–9,

- 7 -✱84ASSIGN ZONE VOICE DESCRIPTORS. See procedure later in this manual.✱85RECORD CUSTOM VOICE DESCRIPTORS. See procedure later in this manual.✱87A

- 8 -✱96INITIALIZES DOWNLOAD ID, SUBSCRIBER ACCOUNT No. FOR INITIAL DOWNLOAD: No entry required.✱97SELECT 1 OF 4 DEFAULT OPTION SETUPS. Enter 1-4 to

- 9 --bSERIAL NUMBEREnter the transmitter’s 7-digit serial number (printed on the transmitter). If an incorrect digit is entered,press the [#] key to