
FIRE ALARM SYSTEM (IF INSTALLED)
General Your fire alarm system (if installed) is on 24 hours a day, providing continuous
protection. In the event of an emergency, the installed smoke and heat detectors will
automatically send signals to your Control/Communicator, triggering a loud,
interrupted sound from the Console. An interrupted sound will also be produced by
optional exterior sounders. A FIRE message will appear at your Console and remain
on until you silence the alarm.
In Case Of Fire
1.
Alarm
2.
3.
4.
Silencing A Fire 1.
Alarm
2.
3.
4.
Should you become aware of a fire emergency before your detectors sense the
problem, o to your nearest Console and manually initiate an alarm by pressin
i
7
the panic ey pair assigned as FIRE emergency (if programmed by the installer
and hold down for at least 2 seconds.
Evacuate all occupants from the premises.
If flames and/or smoke are present, leave the premises and notify your local Fire
Department immediately.
If no flames or smoke are apparent, investigate the cause of the alarm. The zone
descriptor of the zone(s) in an alarm condition will appear at the Console.
Silence the alarm by entering your code and pressing the OFF key. To clear the
display, enter your code and press the OFF key again.
If the Console does not indicate a READY condition after the second OFF
sequence, press the READY key to display the zone(s) that are faulted. Be
sure to check that smoke detectors are not responding to smoke or heat
producing objects in their vicinity. Should this be the case, eliminate the source
of heat or smoke.
If this does not remedy the problem, there may still be smoke in the detector.
Clear it by fanning the detector for about 30 seconds.
When the problem has been corrected, clear the display by entering your code
and pressing the OFF key.
-41-
Comentários a estes Manuais