ADEMCO 4120XM Guia do Utilizador descarregar pdf (Página 20)

12345678

00000000

41mcM

lB2

HEADER

(

10M ‘*

SM12GXMP2

(

)

lRtGGER CASLE

, , , 1 n ,

SA4120XMP-2 Trigger Cable with Pull-ups

(installer-provided) for use with LORRA.

Application

Programming & Wiring

SA4120XM-2 Trigger Cable for use with 4146

Keyswitch & Latching Glass Break Detectors.

An optional Amseco PAL 328N piezo sounder can be used for installations

where it is desired to remote the sounds produced by the console’s built-in

sounder. The control panel will remote all sounds (i.e., alarm, trouble, chime,

entry/exit, etc.) produced by the console except for the short key clicks

associated with console key depression.

One application of this feature might be to produce chime sounds in a location

which is distant from the console(s).

If used, Address 1*57 must be set to “2” or “3”, and the PAL 328N must be

connected to TB2 pin 5, as shown in the diagram below.

ls2

TRIGQER

HEADER

TERMINM5

●

An optional remote 4146 keyswitch can be used for remote arming and

disarming of the system. If used, program field

●I 5 must be set to “1” to

enable the keyswitch option.

The

4146 keyswitch’s normally open momentary switch and LEDs must be

connected to Zone 7 and to the TB2 connector trigger outputs respectively.

A 2000 ohm EOL resistor must be connected across the momentaty switch,

and zones

2-8 must be programmed for EOLR supervision (0) in field 41.

Note:

In view of the above, all zones must be used with EOLR supervision

when a remote keyswitch is

used.

A momentary shori across this zone will arm the system in the “AWAY”

mode. If the short is held for more than 3 seconds, the system will arm in the

“STAY” mode. (i.e., all zones designated as zone types 4 or 10 will be

automatically bypassed). After the system has been armed, the next time

zone 7 is shorted, the system will disarm.

-20-

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 79 80

Comentários a estes Manuais

Sem comentários

ADEMCO 4120XM Guia do Utilizador Página 20

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso ADEMCO 4120XM