ADEMCO 4140XMPT2 Manual do Utilizador descarregar pdf (Página 12)

Type 06

24-hour Went Alarm.

Type 07

24-hour Audible Alarm.

Type 08

24-hour Auxiliary

Alarm.

Type 09

Supewised Fire. (No

Verification)

Type 10

interior w/Deiay.

Type 20

Arm-Stay*

Type 21

Arm=Away*

Type 22

Disarm’

Type 23

No Aiarm Response

This zone type sends a report to the Central Station but provides no console

display or sounding. This zone type is usually assigned to a zone containing an

Emergency button.

This zone type sends a report to the Central Station, and provides an alarm sound

at the console, and an audible external alarm. This zone type is usually assigned

to a zone that has an Emergency button.

This zone type sends a report to Central Station and provides an alarm sound at

the console. (No beii output is provided). This zone type is usually

assigned to a zone containing a button for use in personal emergencies, or to a

zone containing monitoring devices such as water sensors, temperature sensors,

etc.

This zone type provides a fire alarm on short circuit and a trouble condition on

open circuit. The beil output will pulse when this zone type is faulted. This zone

type is always active and cannot be bypassed. This zone type can be

assigned to any wired zone, but oniy certain wireiess systems

zones.

This zone type gives entry delay (using the programmed entry time), if tripped

when the panel is armed in the Away mode. This zone type is also active during

maximum mode, but no delay is provided (alarms occur immediately if zone is

tripped). This zone type is bypassed when the panei is armed in the

Stay or instant modes.

Delay begins whenever sensors in this zone are

violated, regardless of whether or not an entry/exit delay zone was tripped first.

This is a special purpose zone type used with 5800 series wireless pushbutton or

contact closure or opening, and which

will result in arming the system in the STAY

mode

when the zone is activated.

This is a special

purpose zone type used with 5800 series wireless pushbutton or

contact closure or opening, and which will result in arming the system in the

AWAY mode when the zone is activated.

This is a special purpose zone type used with 5800 series wireless pushbutton or

contact closure or opening, and which will result in disarming the system when

the zone is activated.

This zone type can be used on a zone when an output relay action is desired, but

with no accompanying alarm (ex. lobby door access).

● Note that these zone types are not for use by 5700 series devices.

NOTE FOR PANiC KEYS

Keypad panic zones share the same zone response type for all 8 partitions, but

panics may be individually enabled for each partition.

iMPORTANT! FAULT ANNUNCIATION

Polling loop and

RF faults (zones 88-91 & 97) will repori as trouble conditions

only, and as such, should be assigned either zone type 00 if no annunciation is

desired, or zone type 05 if annunciation as trouble condition is desired. See

FAULT ANNUNCIATION notes in POLLING LOOP and WiRELESS EXPANSION

sections for more information.

-12-

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 67 68

Comentários a estes Manuais

Sem comentários

ADEMCO 4140XMPT2 Manual do Utilizador Página 12

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso ADEMCO 4140XMPT2