ADEMCO 4140XMPT2 Manual do Utilizador descarregar pdf (Página 37)

●

O“*AO

SECURITY ACCESS CODES

General Information

User Codes & Levels Of

Authority

Level Title

Instailer

1 Master

●

The System aiiows up to 128 security acoess codes to be assigned (maximum 99

per partition), each identified by a user iD number. in addition, the Quick Arm

feature can aiso be programmed, wh@ enabies the [#] key to be pressed instead

of entering the security code when arming the system. The code must stili be

entered when disarming the system.

Note that Open/Cbse reporting of Quiok Arm is enabied if User 2 is enabied for

Open/Ciose reporiing, and that Quick Arm reports as User O.

Each user of the system can be assigned various Ieveis of authority (tells system

what system functions that user is authorized to do), and can have different ieveis

of authority within each parlition. Use the “View Capabilities” keypad funotion to

view the partitions and authority Ieveisfor which a particular user ~Sauthorized. In

highest to lowest ranking, these ieveis are described below.

nstaller “ Programmedinfield●OO(defautt=4-14-O).

Level O)

Can be changedby installer.

Jser 1

● Can perform aii system functions (arm, disarm, bypass,

etc.) and is the oniy user that can enter program mode.

● Oniy code that aiiows entry to program mode.

s instailer code iockout if exit program mode via ’98. This

prevents instaiier from reaccessing program mode. The

only way to access Programming mode once this feature

is activated, is by powering down the system and

powering up again, and then pressing both the

● and #

keys at

the same time within 30 seconds of power up.

● The instaiier must program at ieast one master

code. Master codes are the codes intended for use by

the primary users of the system.

● Can add, deiete, or change master, manager, or operator

codes.

● Can select open/close reports for any user.

● Can perform normai system functions, but cannot

disarm

if armed by a code other than Instalier’s code

(inoluding Quick Arm).

● Enable open/ciose reporting for instailer in field ●39.

Master (Levei 1)

● The Master Code is the code intended for use by the

primary users of the system when performing system

functions, and oan be changed by the Master User.

● The master codes can be used to assign up to 99 lower

level codes, which can be used by other users of the

system who don’t have a need to know the master code.

● As shipped from the factory, there are no master or

manager codes pre-programmed. The installer must

program at ieast one master code during initiai

instailation.

● Master cannot assgn anybody a ievel of Oor 1.

● Can change his own code.

● Can add, delete, change manager or operator codes.

Each user’s code can be individually eliminated or

changed at any time.

s Open/close reporting of added users are same as that

of the master or manager adding the new user.

● Can perform ali system functions.

-37-

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 67 68

Comentários a estes Manuais

Sem comentários

ADEMCO 4140XMPT2 Manual do Utilizador Página 37

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso ADEMCO 4140XMPT2