ADEMCO 4160-12 C-COM Especificações descarregar pdf (Página 39)

these terminals.

At the last switch, terminate

the

loop with

the furnished 1000 ohn End-of-Line Resistor.

The zone is PROM programnable for either audible or silent alarm.

A separate PROM progratmning option is whether or not the console

should be inhibited from indicating the silent alarm (e.g. inhibit

for. hold-up but permit indication if used for medical).

Maximum permissible resistance in the zone is 600 ohms (plus

the

1000

ohm End-of-Line Resistor).

This zone has a

normal

response

(250 msec) to activations.

13,14 ZONE 6 Uergey

or Burglary Protection he

This zone may be PROM programned

a 24 hour audible EMERGENCY

zone, in which case it provides an additional means to activate

the emergency alarm that can be triggered by simultaneous depression

of the two EMERG keys on the console.

Connect open circuit

momentary switches (e.g. Nos. 219, 273, 4024, 4026) in parallel

across these terminals or closed circuit momentary switches

(e.g. Nos. 273, 4024, 4026) in series with these terminals.

This zone may alternatively be PROM programed as a night burglary

protection zone.

has attributes similar to Zones l-3. The

zone is strictly an instant alarm zone (not programmable for

delay). When the zone is programmed for burglary protection,

the EHERG keys on the console are not usable.

The zone has

normal response

(250 nsec) to alarm activations.

At the

last

device, terminate the loop with the furnished

1000

ohm ,End-of-Line Resistor. Maximum permissible resistance in

the zone is 600 ohns (plus the

1000

ohn End-of-Line Resistor).

Consol e/Keypad Data Xnput :

This terminal is one of.the four

wire connection points (GREEN) for remote keypads and security

consoles.

Oata entered from the keypads on these units is fed

into the C-COM at this terminal.

18 Circuit 6round (-) Return

Switched Power Output:

This terminal provides a HI output (5

MA. MAX) when comnunication is underway, for control of a listen-

in device or for activation of a remote LED.

Circuit Ground (-) Return:

This terminal is one of the four

wire connection points (BLACK) for remote keypads and security

consoles.

Console/Kepad Data Output:

This terminal is one of the four

wire connection points (YELLOW) for remote keypads and security

consoles. Data from the C-CON to activate displays and audible

sounding is fed to the keypads and consoles from this terminal.

6.5 Volt Continuous Power (+) for Powering l&a&e Keypads and

Security Consoles: 675

MA.

MAX.

628-39

716

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 58 59

Comentários a estes Manuais

Sem comentários

ADEMCO 4160-12 C-COM Especificações Página 39

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso ADEMCO 4160-12 C-COM