ADEMCO 4160-12 C-COM Especificações descarregar pdf (Página 9)

ALT by 2's (Alternate by Pairs)

This option,

when PROM selected, will cause the communicator

to alternate between the primary receiver and the secondary

receiver while. it is attempting to get through.

It will first

make two attempts to the primary receiver, then two attempts

to the secondary receiver

, and so on until it either receives

a kissoff signal from one receiver or exhausts the maximum number

of attempts.

5. Camnicator Restore Report Enable

If a zone is set up as a restore zone (see control option f14) and

.it is desired to communicate restore, the reporting can be PR@l enabled

for any such zone or zones.

6. &municator Channel

Asstg-t

On the system , each alarm zone, as well as the duress report,may

be assigned a communicator channel.

How the zones are assigned to

channels affects the types of reports that will be sent. As an example,

each zone could be given a different communicator code for unique

zone reporting.

& the zones could be grouped by function with duress

and silent panic zones as Channel (or Code) 1, the fire zone as Channel

(or Code) 2, and the burglary zones as Channel (or Code) 3 (this

would allow the system to be compatible with an existing central

station alarm code scheme).

7. Frunicator Fomat

Individually selectable for primary and Secondary telephone numbers -

Ademco LOW Speed and/or Ademco High Speed, Sescoa, Radionics Superfast.

II.

FURCTIDRU OESCRIPTIDR

FUETIOML DESCRIPTION, ND. 4160-12 C-C@! (See

Diagram 4)

1. suitcbes:

FIRE TEST/RESET Sri tch:

Rightward movement of this momentary

action, center off switch shorts the fire loop to initiate an

al arm.

In addition, the charging current to the battery is

interrupted while this switch is held, giving an indication

of battery condition.

The test is reported to the central station

using the Test code. The fire test is reset by sliding the

switch to the RESET po.sition.

Leftward movement of this switch resets the fire circuit. In

addition, the power to the smoke detectors is interrupted, resetting

any detectors that were activated. Clearing of the fire alarm

memory indication on the console and on the C-CCM requires entry

of the security code and OFF at a console or keypad.

In addition, the fire circuit may be bypassed by holding the

switch to the left f6r 5 seconds.

A fire trouble indication

will be provided when the fire circuit is bypassed.

628-9

686

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 58 59

Comentários a estes Manuais

Sem comentários

ADEMCO 4160-12 C-COM Especificações Página 9

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso ADEMCO 4160-12 C-COM