ADEMCO 4160-12 C-COM Especificações descarregar pdf (Página 45)

VI.

SYSTEM CNCKOUT

Perform these tests after the wiring and option selections desired in

the

previous sections have been canpleted.

Install both the control and the communicator PR@k (No. 691),-into

their respective sockets (see Diagram 4) after making certain that

there is no power going to the system. Take care td align the PfWM

orientation marks.

Install

the PROMS using the No. 692 Insertion'

Tool.

Connect the telephone 1 ine and handsets via a h. 620 Direct Connect

Cord (See Diagram 4).

Connect the battery

by connecting the plug at the end of the black

and

red wires coming from the battery to the socket connector at

the end of black and red wires coming from the circuit board. Rapid

beeping will occur,

0 will briefly appear on the console display

at the upper right, and the READY light will go on.

Enter the security

code and OFF to stop the beeping.

Plug the transformer into a

llOV.AC

‘outlet that is ON 24 hours a

hY*

The POWER LED will light on the Security Console and on the

c-ml.

Observe the Digital Display on the Security Console after depressing

tk READY l&y. lWhing will appear if the protective loops are properly

wired and all contacts are properly set.

Similarly, none of the

.zone status LEDs on the C-COM will be lit.

With 110 alarm or trouble being indicated,

do the following and observe

the response:

Open each of the burglary zones momentarily,

one at a time.

The appropriate zone n.unber should appear on the Security Console

Zone I.D. Display and the appropriate zone LED should light

on the C-COP while the zone is open.

Short each of the burglary zones momentarily.

one at a time.

The appropriate zone number should appear on the Security Console

Zone I.D. Display and the appropriate zone LED should light

on the C-COM while

the

zone

shorted.

NOTE: If

Zone

has been set up

as a D&Night Zone (trouble by day,

alarm by night), the above actions will also cause the

CHECK

display to light on the Security Console, the CHK.BYP LED on

any Remote Keypad (if used) to light, and the Zone 4 TRBL LED

on the C-COM to lfght.

addition, the Security Console and

the Remote Keypad will produce a rapidly pulsing sound.

zone 4 has been set up

as a fire

zone, do the following:

Observe the C)(ECK display on the Security Console or the CRK.BYP

LED on any Remte Keypad or the Zone 4 TRBL LED on the C-COW.

They should be off if the protective loop and detector power

circuits are properly wired.

628-45

722

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 58 59

Comentários a estes Manuais

Sem comentários

ADEMCO 4160-12 C-COM Especificações Página 45

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso ADEMCO 4160-12 C-COM