ADEMCO VISTA-20HWse Guia de Resolução de Problemas descarregar pdf (Página 38)

–38–

Section 13.

ZONE RESPONSE TYPE DEFINITIONS

General Information

You must assign a zone type to each zone, which defines the way in which the

system responds to faults in that zone. Zone types are defined below.

Type 00

Zone Not Used

Program a zone with this zone type if the zone is not used.

Type 01

Entry/Exit Burglary #1

This zone type provides exit and entry delays whenever the zone is faulted if the

control is armed in the Away or Stay modes. When the panel is armed in the

Instant or Maximum modes, no entry delay is provided. Entry delay #1 is

programmable from 0-99 seconds for each partition.

Exit delay begins whenever the control is armed, regardless of the arming mode

selected, and is independently programmable form 0-99 seconds (field *34).

This zone type is usually assigned to sensors or contacts on doors through which

primary entry and exit will take place.

Type 02

Entry/Exit Burglary #2

This zone type provides a secondary entry delay whenever the zone is faulted if

the panel is armed in the Away and Stay modes. When the panel is armed in the

Instant or Maximum modes, no entry delay is provided. Entry delay #2 is

programmable from 0-99 seconds for each partition.

The programmed exit delay (field *34) begins whenever the control is armed,

regardless of the arming mode selected.

This zone type is usually assigned to sensors or contacts on doors through which

secondary entry and exit will take place, and where more time might be needed

to get to and from the keypad (typically used for a garage, loading dock, or

basement door).

Type 03

Perimeter Burglary

This zone type gives an instant alarm if the zone is faulted when the panel is

armed in the Away, Stay, Instant or Maximum modes. This zone type is usually

assigned to all sensors or contacts on exterior doors and windows.

Type 04

Interior, Follower

This zone type gives a delayed alarm (using the programmed Entry/Exit time) if

the Entry/Exit zone is faulted first. Otherwise this zone type gives an instant

alarm. This zone type is active when the panel is armed in the Away and

Maximum modes. This zone type is bypassed automatically when the panel

is armed in the Stay or Instant modes. This zone type is usually assigned to a

zone covering an area such as a foyer, lobby, or hallway through which one must

pass upon entry (After faulting the entry/exit zone to reach the keypad to disarm

the system.)

Since this zone type is designed to provide an instant alarm if the entry/exit zone

is not violated first, it will protect an area in the event an intruder hides on the

premises prior to the system being armed, or gains access to the premises

through an unprotected area.

Type 05

Trouble by Day/

Alarm by Night

This zone type will give an instant alarm if faulted when armed in the Away, Stay,

Instant or Maximum (night) modes. During the disarmed state (day), the system

will provide a latched trouble sounding from the keypad (and a central station

report, if desired). This zone type is usually assigned to a zone which contains a

foil-protected door or window (such as in a store), or to a zone covering a

"sensitive" area such as a stock room, drug supply room, etc. This zone type can

also be used on a sensor or contact in an area where immediate notification of an

entry is desired.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 83 84

Comentários a estes Manuais

Sem comentários

ADEMCO VISTA-20HWse Guia de Resolução de Problemas Página 38

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso ADEMCO VISTA-20HWse