ADEMCO VISTA-20HWse Guia de Resolução de Problemas Página 42

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 84
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 41
42–
*
36 ENTRY DELAY 02 6| 0 6| 0
00-99 = entry delay time for each partition in secs. Part. 1 Part. 2
The system will wait the time entered before sounding alarm upon
entering.
UL installations: must be set for a maximum of 20 seconds
*
37 AUDIBLE EXIT WARNING 1 1
0 = no exit warning sound Part. 1 Part. 2
1 = provide exit warning sound when armed AWAY
Warning sound consists of slow continuous beeps until last 5 seconds,
when it changes to fast beeps. The warning sound will end at the
termination of Exit time.
*
38 CONFIRMATION OF ARMING DING 0 0
0 = no ding Part. 1 Part. 2
1 = confirmation ding after arming system
Confirmation of arming is 1/2 second external sounder “ding” when
closing report is sent, or at the end of exit delay.
*
39 POWER UP IN PREVIOUS STATE 1
0 = always power up in a disarmed state
1 = assume the system status prior to power down
When the system powers up armed, an alarm will occur 1 minute after
arming if a zone is faulted.
Note that if the previous state was armed AWAY or STAY, the system will
not respond to sensor changes for 1 minute, which allows time for sensors
such as PIRs to stabilize.
UL installations: must be 1 (power up in previous state)
DIALER PROGRAMMING
(
*
40Ð
*
50)
*
40 PABX ACCESS CODE (See Box at Left) | | | | |
Enter up to 6 digits if PABX is needed to access an outside line. If fewer
than 6 digits are needed to be entered, exit by pressing [
*
] and next field
number (e.g., 41). To clear entries from field, press
*
40
*
.
Fields
*
40,
*
41,
*
42:
Enter up to the number of
digits shown. Do not fill
unused spaces.
Enter 0–9,
# + 11 for ‘
*
# + 12 for ‘#’
# + 13 for a pause
(2 seconds)
*
41 PRIMARY PHONE No. (See Box at Left)
| | | | | | | | | | | | | | | Ê
Enter up to 16 digits. If fewer than 16 digits entered, exit by pressing [
*
]
and next field number (e.g., 42). To clear entries from field, press
*
41
*
.
Note: Back-up reporting (8 calls are made to the secondary phone
number if no kiss-off is received after 8 attempts to the primary number)
is automatic only if there is a secondary phone number (field
*
42).
*
42 SECONDARY PHONE No. (See Box at Left)
| | | | | | | | | | | | | | | Ê
Enter up to 16 digits. If fewer than 16 digits entered, exit by pressing [
*
]
and next field number (e.g., 43). To clear entries from field, press
*
42
*
.
See back-up reporting note for field *41. If using the pager feature, enter
the pager phone number here.
Vista de página 41
1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 83 84

Comentários a estes Manuais

Sem comentários