ADEMCO VISTA-20HWse Guia de Resolução de Problemas descarregar pdf (Página 66)

–66–

ÊÊÊSection 21. SYSTEM OPERATION

Security Codes

Installer Code

The installer programs the 4-digit Installer Code initially as part of the

programming procedure. The factory default Installer code is "4-1-1-2", but may

be changed in field

20.

The Installer code is the only code that can enter programming mode and also, in

normal operation mode, is used to enter the Master code for each partition, which

allows access to the normal functions of the system.

Master Code

In normal operation mode, the Installer code is used to enter the 4-digit Master

security code for each partition, using

the keypad connected to Partition 1

To enter the Master code for Partition 1,

enter:

Installer Code + [8] + [01] + desired 4-digit Master code for Partition 1

To enter the Master code for Partition 2,

enter:

Installer Code + [8] + [02] + desired 4-digit Master code for Partition 2

To change the Master code,

enter:

Current Master code + [8] + [02] + new Master code + new Master code again

Secondary User Codes

In normal operation mode, each partition's Master security code can be used to

assign up to 12 secondary 4-digit security codes plus a babysitter code and a

duress code for that partition. The master code can also be used to remove

secondary codes from the system (individually).

To assign (or change) a Secondary security code,

enter

(via partition's

keypad)

Partition's Master Code + [CODE key] + User # (03–16) +

desired Secondary Code

The system will emit a single beep when each secondary code has been

successfully entered.

To delete a Secondary security code,

enter

(via partition's keypad)

Partition's Master Code + [CODE key] + User # (03–16)

Notes: • All Master and Secondary security codes permit access to the system for

arming, disarming, etc.

• The installer code can disarm the system only if it was used to arm it.

• Babysitter code is User code No. 15; i.e., it can disarm the system only if it

was used to arm it.

• Duress code is User code No. 16. When this is used to perform any system

operation, a special code is sent to the monitoring station. Instruct users to be

careful not to use this code for normal usage.

• If a secondary code is inadvertently repeated for different users, the lower

user number will take priority.

• Opening and closing reports are sent for the Installer code as No. 01, with the

appropriate subscriber number. Each Master code and set of secondary user

codes are sent as Nos. 02, and 03–16 respectively in Contact ID format (with

the appropriate subscriber number); in 4+2, it is 1–F, “F” for anything greater

than 14.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 83 84

Comentários a estes Manuais

Sem comentários

ADEMCO VISTA-20HWse Guia de Resolução de Problemas Página 66

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso ADEMCO VISTA-20HWse