ADEMCO 4140XMPT2 Manual do Utilizador descarregar pdf (Página 107)

– 107 –

User Codes & Levels Of

Authority (cont.)

Manager (Level 2) • Can perform all system functions (Arm, Disarm, Bypass,

etc.) programmed by Master.

• May create other users of the system below this level

(Manager cannot assign anybody a level of 0, 1, or 2).

• May change his own code.

• May add, delete, change operators.

• Open/close reporting of added users will be same as his

own (enabled or disabled as assigned by installer or

master).

• May operate a partition.

Operator • Operators can arm and disarm the system to the authority

(Levels 3-5) assigned, but cannot add or modify any user code.

• May operate a partition with one of the three

OPERATOR authority levels A through C listed below.

Level Title Functions Permitted

3 Operator A Arm, Disarm, Bypass

4 Operator B Arm, Disarm

5 Operator C Arm, Disarm only if armed with

same code

• Operator C (sometimes known as Baby-sitter code),

cannot disarm the system unless the system was armed

with that code. This code is usually assigned to persons

who may have the need to arm and disarm the system at

specific times only (ex. a baby-sitter needs to control the

system only when baby-sitting).

Duress (Level 6) • The duress code is a means of sending a silent alarm to a

central monitoring station if the user is being forced to

disarm (or arm) the system under threat. This feature is

only useful if the system is connected to a central station.

• When the system's Auxiliary Voltage Triggers are

connected to another communication's media, note that

duress is signaled on the same trigger that signals silent

panic (whereas duress has its own unique report when

digitally communicated).

• The duress code is assigned on a partition by partition

basis and can be any code desired.

• When used, the system will disarm (or arm), but will also

send a silent alarm to the central station (if service is

connected). There will be no indication at the console

that an alarm was sent..

• Duress Reporting Note: The Duress report triggering

logic activates on the 5th key depression (such as OFF),

not the 4th key depression (last digit of code). Duress

reports will not be triggered if the 5th key is a [*], such as

when performing a GOTO or viewing the capabilities of a

user.

Open/Close Reporting Note: When adding a user, the system will only

prompt for Open/Close report capability if the user is being added by the Installer.

When a Master or Manager adds a new user, the new user's Open/Close

reporting enable will be the same as that of the Master or Manager adding the

user. If Open/Close reports are required to be selectable by the Master or

Manager, the Installer should assign two Master or Manager user codes: one with

Open/Close reporting enabled, and one without Open/Close reporting.

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 131 132

Comentários a estes Manuais

Sem comentários

ADEMCO 4140XMPT2 Manual do Utilizador Página 107

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso ADEMCO 4140XMPT2