ADEMCO 4140XMPT2 Manual do Utilizador descarregar pdf (Página 52)

– 52 –

Section 3. DATA FIELD PROGRAMMING

PROGRAMMING SYSTEM-WIDE (GLOBAL) DATA FIELDS

General Procedure The global (i.e. non partition-specific) programming fields are grouped into three

sets (referred to as "pages"), as represented in the diagram below. The first page

is accessed as soon as programming mode is entered. To access the other pages

of fields (indicated on the programming form by a "1" or "2" in front of the 2-digit

field address), press *94. Note that the alpha consoles display the words ALT

PROGRAM MODE along with a "1" or "2", depending on which page of

programming fields are accessed, to indicate the higher page of fields. To return

to the previous page of fields, press *99.

Enter programming mode

(installer code + 8 + 0 + 0)

Enter the first field number (ex. *00, installer's code)

to move to first page

First Page of fields

(*00-*90)

press *99 or *98

to exit program

mode

press *94 to move to 2nd page press *99 to move back to 1st page

second page of fields

(1*01-1*76)

press *94 to move to 3rd page press *99 to move back to 2nd page

third page of fields

(2*00-2*21)

To program specific data fields, press [

] plus the 2-digit field address,

then make the required entry. The console will beep when a field has been

completely programmed and will automatically display the next field in sequence.

Partitioned programming fields are skipped (refer to PARTITIONING

PROGRAMMING paragraph). If the number of digits that you enter in the data field

is less than the maximum permitted (ex. phone number), the console displays the

last entry and waits. To proceed, the next data field to be programmed must be

entered manually (ex. press *05).

To view the contents of a data field, press [#] plus the 2-digit field

address. The field's entries will be displayed, but no changes can be made.

In case of errors: If an address is improperly entered, the console will display

FC. If a program entry is improperly entered (for example, a larger number than

that which is permitted), the console display will go blank. In either case, simply re-

enter the correct number.

SUMMARY OF DATA FIELD PROGRAMMING COMMANDS

*94 Next page of fields

*99 Previous page of fields or exit programming mode with no installer lockout

*91 Select partition for programming partition-specific fields

#93 Enter Zone/Alpha/Device Programming mode

*98 Exit programming mode with installer lock-out

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 131 132

Comentários a estes Manuais

Sem comentários

ADEMCO 4140XMPT2 Manual do Utilizador Página 52

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso ADEMCO 4140XMPT2