ADEMCO 4140XMPT2 Manual do Utilizador Página 131
- Página / 132
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
++
-
N.C.
N.C.
N.O.
2k EOLR
(note 1)
2k EOLR
(note 1)
+-
+
-
+-
BELL
SIREN
NO CONNECTION
TRANSFORMER
16.5VAC, 40VA
ADEMCO No.1361
(IN CANADA
USE No. 1361CN)
or 4300 TRANS-
FORMER IF X-10
DEVICES
WILL BE USED
Connect to
24-hr. 120VAC,
60 Hz Outlet
Red Blk
Grn Yel
++
-
N.C.
N.C.
2k EOLR
(note 1)
2k EOLR
(note 1)
++
-
N.C.
+
+
-
N.C.
N.C.
2k EOLR
(note 1,4)
TIP
(BROWN)
RING
(GRAY)
TIP
(GREEN)
RING
(RED)
Handset
Incoming
Phone Line
Telephone connections
USING RJ31X direct
connect cord
EARTH GROUND
Connect to good earth
ground to maintain im-
munity to transients.
See Instructions for
proper grounding.
SMOKE
4190
RPM
4278
PIR
Polling loop rating: 64mA max.
See Installation Instructions for
maximum number of devices
supported and maximum
wire run length.
4140XMPT2 SUMMARY OF CONNECTIONS
Zone resistance (Excluding EOLR):
ZONE 1, 8: 100 OHMS MAX.
ALL OTHER ZONES: 300 OHMS MAX.
ZONE 1
ZONE 2
ZONE 3 ZONE 4
ZONE 5 ZONE 6 ZONE 7
ZONE 8 ZONE 9
2-WIRE SMOKE
DETECTOR LOOP
(Also supports NO/NC Burg contacts)
POLLING LOOP
Programmable Response
(Fast/Normal) Loop
LATCHING TYPE GLASS
BREAK DETECTOR LOOP
Data in
Data out
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26
27
28 29 30
RED (+)BLK (-)
Connect to
12VDC, 4AH
or 12VDC, 7AH
GEL CELL
BATTERY
CHARGING
VOLTAGE
13.7VDC
See
Installation
Instructions for
required
battery capacity
Replace
every
3 years
NOTE:
WHEN POWERING UP
THE PANEL, PLUG THE
TRANSFORMER IN BEFORE
CONNECTING THE BATTERY.
See Installation Instructions
for type & max # of keypads,
and for max wire run length.
ALARM SOUNDER OUTPUT 10VDC - 13.8VDC
2.8A maximum
AUXILARY POWER OUTPUT
9.6VDC - 13.8VDC,750mA max.
Note: Include current drawn
by keypads and polling loop
devices when making
auxiliary power calculations.
+
-
NOTES:
1. Zone 1 may be selected for EOLR supervised
or normally closed (no EOLR) operation via cut
jumper. (Cut red jumper for normally closed operation.
Do not cut for Fire Usage). Zones 2-8 may be selected
for either operation via program field
*
41.
Zone 1 supports 2-wire smoke detectors.
See Installation Instructions for recommended type
and maximum number of detectors supported.
Zone 7 may be used for remote keyswitch arming/disarming.
See Installation Instructions for wiring instructions.
2.
3.
1 2 3 4 5 6 7 8 9
1. Not Used
2. Ground-
3. Out 1 (Ground Start)
4. Ground-
5. Out 2 (fire)
6. Ground-
7. Out 3 (burg/aud. panic)
8. Ground
9. Out 4 (silent panic/
duress)
Optional programming:
Out 1: Open/close or Keypad-like sounding
Out 2: Armed LED
Out 4: Ready LED
Ratings for Out 1:
Active: 10VDC-13.8VDC through 4k OHMS
Not Active: 100 OHMS to ground
Ratings for out 2-4:
Active: 10VDC-13.8VDC through 5k OHMS
Not Active: 1k OHMS to ground
N.C.
N.O.
N.O. N.O.
2k EOLR
(note 1,2)
N.O. N.O.
N.O.
N.C.
N.O.
2k EOLR
(note 1)
2k EOLR
(note 1,3)
N.C.
+
-
J7
GLASS
BREAK
1 2 3 4 5 6 7 8 9
J8
MAKE CONNECTIONS USING
No. 4142TR CABLE
WARNING: OWNER'S INSTRUCTION NOTICE NOT TO BE REMOVED
Fire
Usage
Burg.
Usage
1. In 2
2. Ground
3. In 3 (4300 sync)
4. In 4 (4300 sync)
5. Ground
6. Out 5 (4300 data)
7. Out 6
8. Ground
9. Ground
Red Jumper
(note 1)
J7 Header J8 Header
BATTERY
TABS
4192SD
SMOKE
WARNING: TO PREVENT
RISK OF ELECTRICAL
SHOCK, DISCONNECT
TELCO JACK BEFORE
SERVICING THIS PANEL.
WEEKLY TESTING IS REQUIRED TO ENSURE PROPER OPERATION OF THIS SYSTEM.
THIS DEVICE COMPLIES WITH PART 15 OF FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT
ANY INTERFERENCE RECEIVED, INCLUDING
INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
(Refer to Installation Instructions for information concerning Direct Wire
Downloading using the 4100SM Serial Module.)
COMPLIES WITH FCC RULES, PART 68
FCC REGISTRATION NO. AC398U-68192-AL-E
RINGER EQUIVALENCE: 0.7B
REMOTE KEYPAD
(Use 6128/6139 only)
(Addressable keypads)
Zone response time:
ZONES 1-8: 350mSec-500mSec
ZONE 9: Programmable for
Fast: 10mSec-15mSec
Normal: 350mSec-500mSec
(default response)
Zone 8 supports 2-wire latching type glass break detectors.
See Installation Instructions for recommended type and
maximum number of detectors supported.
4.
4140PT2-SOC-V0
DOC LOAD NO.: 5
COMPLIES WITH FCC RULES, PART 68
FCC REGISTRATION NO. AC398U-68192-AL-E
RINGER EQUIVALENCE: 0.7B
- 4140XMPT2 1
- CONGRATULATIONS! 2
- TABLE OF CONTENTS 3
- INSTALLATION INSTRUCTIONS 6
- SUMMARY OF SYSTEM FEATURES 7
- SCHEDULING OVERVIEW 12
- BASIC 9 HARD-WIRED ZONES 15
- Wire Gauge Max. Length 17
- J7 CONNECTOR 25
- 4142TR CABLE 25
- 1 2 3 4 5 6 7 8 9 26
- IST OF START 29
- URN ON LIGHTS 29
- ELL OUTPUT 30
- TROBE LIGHT 30
- YSTEM STATUS INDICATORS 30
- ONFIRMATION OF ARMING DING 30
- NLOCK EXIT DOORS 31
- URN ON EMERGENCY LIGHTING 31
- OUNDING FOR WIRELESS KEYPAD 31
- Section 3 32
- REMOTE CONSOLES, SOUNDERS 32
- & PHONE CONNECTIONS 32
- Wire Gauge Maximum Length 33
- EXTERNAL SOUNDERS 34
- PHONE CONNECTIONS 34
- Section 4 35
- POWERING THE SYSTEM 36
- (total poll loop worksht) 37
- Section 7 39
- Section 8 41
- PROGRAMMING GUIDE 42
- 00-15; 00=no suppression 43
- RF Trans. Type 46
- Section 2 50
- INDEX TO PROGRAMMING FIELDS 53
- DATA FIELD DESCRIPTIONS 54
- (refer to #93 and 60
- — 61 — 61
- Selected Partitio 61
- Set of Fields 61
- — 63 — 63
- 2nd Page Fields 63
- ALPHA VOCABULARY 75
- CHARACTER (ASCII) CHART 75
- COMMUNICATION FORMATS 76
- Code Definition 78
- COMMUNICATION PROGRAMMING 79
- NOTES Note: Low Speed will 80
- Section 6 DOWNLOADING 85
- DIRECT WIRE DOWNLOADING 87
- INTRODUCTION TO SCHEDULING 88
- Note that 00 is 89
- #80 SCHEDULING MENU MODE 92
- Number (HH:MM) (HH:MM) 93
- Hol. Partition 94
- Mon/Day 1 2345678 94
- HOLIDAY NUMBER ? 99
- Action Codes: 100
- 01 RELAY GRP # ? 100
- GROUP ? 12345678 100
- ACCESS SCHED # ? 101
- MON A1 Window 1? 101
- MON A3 Window 2 ? 101
- Hol A1 Window 1 ? 101
- Hol A1 Window 2 ? 101
- #83 USER SCHEDULING MENU MODE 104
- SYSTEM OPERATION 105
- Section 1. SYSTEM OPERATION 106
- User 3 User 5 108
- Level 1 Level 4 108
- Master Oper B 108
- KEYPAD FUNCTIONS 111
- Part. 1 WHSE 112
- User 01 Auth.=1 112
- PRINTER DTR 114
- BYPASS EVENT LOG 115
- SYSTEM EVENT LOG 115
- DIP SWITCH POSITION 121
- 4275EX PIR 122
- 4194 REED CONTACT 122
- (SURFACE MOUNT) 122
- 4278EX PIR 122
- IMPORTANT 123
- SET SWITCHES WITH 123
- BATTERY REMOVED 123
- Section 6. SPECIFICATIONS 124
- WARNING! 130
- RINGER EQUIVALENCE: 0.7B 131
- © 1996 PITTWAY CORPORATION 132
Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso ADEMCO 4140XMPT2
(88 páginas)
(61 páginas)
(132 páginas)© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.046 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais