ADEMCO 4140XMPT2 Manual do Utilizador descarregar pdf (Página 35)

– 35 –

Section 4.

MOUNTING THE CONTROL, PC BOARD & LOCK

General The 4140XMPT2 is supplied with a 12.5"W x 14.5"H x 3"D cabinet suitable for

use in residential and non-certified commercial burglary installations.

Mount the Control cabinet to a sturdy wall using fasteners or anchors (not

supplied) in a clean, dry area which is not readily accessible to the general public.

The back of the Control cabinet has 4 holes for this purpose.

Follow the instructions below for mounting the 4140XMPT2 PC board into the

cabinet and for mounting the Control's lock to its cabinet door.

Mounting The 4140XMPT2

PC Board

Before mounting the circuit board, be certain that the appropriate metal

knockouts have been removed. DO NOT ATTEMPT TO REMOVE THE

KNOCKOUTS AFTER THE CIRCUIT BOARD HAS BEEN INSTALLED.

1. Hang the three mounting clips on the raised cabinet tabs. Observe proper

clip orientation to avoid damage to the clip when mounting screws are

tightened and to avoid problems with insertion and removal of the PC board.

2. Insert the top of the circuit board into the slots at the top of the cabinet. Make

certain that the board rests in the slots as indicated in step 2 detail.

3. Swing the base of the board into the mounting clips and secure the board to

the cabinet with the accompanying screws (as illustrated in step 3 detail).

Advisory Make certain that the mounting screws are reasonably tight to insure that there is

a good ground connection between the PC board and the cabinet. Also, dress

field wiring away from the microprocessor (center) section of the PC board. The

cabinet provides 2 loops on its left and right sidewalls for anchoring field wiring

using tie wraps. These steps are important to minimizing the risk of panel RF

interference with television reception.

3RD CLIP

REQUIRED

DETAIL SIDE VIEW OF CLIP INSTALLATION

A-CABINET TAB WITHOUT CLIP

B-CABINET TAB WITH HANGING CLIP

DETAIL SIDE VIEW OF CLIP AND

BAORD INSTALLED

DETAIL SIDE

VIEW OF BOARD

INSERTED INTO

SLOTS

Mounting The Cabinet Lock 1. Remove the lock knockout on

the control cabinet cover. Insert

the key into the lock. Position the

lock in the hole making certain

that the latch will make contact

with the latch bracket when the

door is closed.

2. While holding the lock steady,

insert the retainer clip into the

retainer slots.

RETAINER

CLIP

RETAINER CLIP

(NOTE POSITION)

RETAINER

SLOTS

LOCKED

UNLOCKED

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 131 132

Comentários a estes Manuais

Sem comentários

ADEMCO 4140XMPT2 Manual do Utilizador Página 35

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso ADEMCO 4140XMPT2