ADEMCO VISTA-128B Guia de Configuração descarregar pdf (Página 174)

VISTA-128B Installation Instructions

24-2

Auto Arming

• The system can automatically arm (AWAY Mode) a partition at the end of a pre-

determined closing (arming) time window.

• Auto arming can be delayed three ways: by use of the auto arm delay, the auto arm

warning, or by manually extending the closing (arming) time window with a keypad

command.

• The system can also automatically bypass any open zones when auto arming.

Auto-Arm Delay

• Auto-arm delay provides a delay (grace period) before auto arming.

• It starts at the end of the closing time window.

• The delay is set in 4-minute increments, up to 56 minutes in partition-specific program

field 2*05.

• At the expiration of this delay, the auto-arm warning will start.

Auto-Arm Warning

•

The auto-arm warning causes the keypad sounder to warn the user of an impending

auto-arm.

•

The warning can be set from 1 to 15 minutes prior to the arming in partition-specific

program field 2*06.

•

During this period the keypad beeps every 15 seconds and displays "AUTO ARM

ALERT.” During the last 60 seconds, the keypads begin to beep every 5 seconds.

•

The panel arms at the conclusion of the auto-arm warning period.

Extend Closing Window

• A user can manually delay the arm (closing) time window by 1 or 2 hours.

• This is done by entering a keypad command ([User Code} + #82), which then prompts the

user to enter the desired extension time of 1 or 2.

• This feature is useful if a user must stay on the premises later than usual.

• The auto-arm delay and warning periods will begin at the end of the extension.

Force Arm

• The force arm option causes the panel to attempt to bypass any faulted zones prior to

auto-arming (panel will perform a force-arm).

• This option is set in partition-specific program field 2*08.

Auto Disarming

• The system can automatically disarm a partition at the end of a pre-determined opening

(disarm) time window.

• The disarming time can be delayed by using the auto-disarm delay feature.

Disarm Delay

• Auto-disarm delay provides a delay before auto disarming. This delay is added to the end

of the disarm time window.

• The delay is set in 4-minute increments, up to 56 minutes, in partition-specific program

field 2*07.

1 2 ... 169 170 171 172 173 174 175 176 177 178 179 ... 251 252

Comentários a estes Manuais

Sem comentários

ADEMCO VISTA-128B Guia de Configuração Página 174

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso ADEMCO VISTA-128B