ADEMCO VISTA-128B Guia de Configuração descarregar pdf (Página 224)

VISTA-128B Installation Instructions

29-6

When defining Speed Key sequences, do not use the [#] key to represent Quick Arming. The

system uses the code entered in response to the prompt to initiate commands in a Speed Key

sequence, so the quick arm key is unnecessary. The system interprets the use of the [#] key in a

Speed Key sequence as its designated function only (e.g. #2 is not interpreted as "Arm-AWAY,"

but rather as "Enter House ID Sniffer Mode").

Executing Speed Key Sequence

To execute a Speed Key sequence, do the following:

If a lettered key, A-B-C, has been assigned as a Speed Key, press the appropriate key. If a

user code is required for any part of the Speed Key sequence, the following prompt appears.

Otherwise, the Speed Key sequence automatically begins.

ENTER USER CODE

✴✴✴✴

Enter your user code. The programmed Speed Key sequence will begin automatically.

To activate a Speed Key not assigned to the A-B-C keys, press and hold down the [D] key for

2 seconds until the following prompt appears:

ENTER SPEED KEY #

01-32 00=QUIT

Enter the desired Speed Key number.

If a user code is required for any part of the Speed Key sequence, the following prompt

appears. Otherwise, the Speed Key sequence automatically begins.

ENTER USER CODE

✴✴✴✴

Enter your user code. The programmed Speed Key sequence will begin automatically.

The system will apply the user code’s Global Arming capabilities if the macro executes any arming

or disarming commands.

Manual Relay Activation Mode (#70 Mode)

The system allows users to manually activate relays by keypad command using either the

keypad or a telephone keypad (if VIP Module is used). The user will be prompted (either by

keypad alpha display or telephone voice module).

To activate relays from a keypad, enter 4-digit

[Security Code] + [#] +70.

To activate relays using a telephone and VIP Module, first dial the 2-digit phone access code.

When the system acknowledges the access, enter 4-digit

[Security Code] + [#] + 70

. The

following prompts/voice responses will begin.

ENTER DEVICE NO.

00=QUIT 01

Voice:

"ENTER DEVICE CODE NOW"

Enter the 2-digit number of the relay to be activated.

1 2 ... 219 220 221 222 223 224 225 226 227 228 229 ... 251 252

Comentários a estes Manuais

Sem comentários

ADEMCO VISTA-128B Guia de Configuração Página 224

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso ADEMCO VISTA-128B