ADEMCO Security System VISTA-15CN Guia de Configuração descarregar pdf (Página 37)

Section 6 - Wireless Expansion

6–7

Installing 5800 Series Transmitters

To be sure reception of the transmitter's signal at the proposed mounting location is

adequate, perform a Go/No Go Test.

Go/No Go Test Mode

The Go/No Go Tests verify adequate RF signal strength from the proposed transmitter

location. They allow you to reorient or relocate transmitters, if necessary, before mounting

the transmitters permanently.

This mode is similar to the Transmitter Test mode, except that the wireless receiver gain is

reduced. This enables you to make sure that the RF signal from each transmitter is received

with sufficient signal amplitude when the system is in the normal operating mode.

1. With at least one 2-line alpha keypad (6139) connected to the system, enter Installer

code + # + 4 on the keypad.

2. After you have placed transmitters in their desired locations and have run the

approximate length of wire from the sensors to the transmitter's screw terminals (if used),

fault each transmitter. Do not conduct this test with your hand wrapped around the

transmitter, as this causes inaccurate results.

NOTE: On button-type transmitters whose buttons have been set to Arm-AWAY, Arm-

STAY, or Disarm, pressing a button takes the system out of the Go/No Go Test mode and

cause that action.

a. The keypad beeps three times to indicate signal reception and display the appropriate

zone number.

b. If the

keypad

does not beep, re-orient or move the transmitter to another location.

Usually a few inches in either direction are all that is required.

3. If each transmitter produces the proper keypad response when it is faulted, you can then

permanently mount each of the transmitters according to the instructions provided with

them.

4. Exit the Go/No Go test mode by entering 4112 (the Installer code) + OFF.

Setting DIP Switches on the 5827 Transmitter(s)

You must set a 5827 Transmitter to the programmed House ID, using its DIP switches.

1 2 3 4 5

DIP SWITCH POSITIONHOUSE

12345

1 ----UP

2 ---UP-

3 - - - UP UP

4--UP--

5--UP-UP

6--UPUP-

7 - - UPUPUP

8 -UP---

9 - UP - - UP

10 - UP - UP -

11 - UP - UP UP

12 - UP UP - -

13 - UP UP - UP

14 - UPUPUP -

15 - UPUPUPUP

16UP----

DIP SWITCH POSITIONHOUSE

12345

17 UP - - - UP

18 UP - - UP -

19 UP - - UP UP

20 UP - UP - -

21 UP - UP - UP

22 UP - UP UP -

23 UP - UPUPUP

24 UP UP - - -

25 UP UP - - UP

26 UP UP - UP -

27 UP UP - UP UP

28 UP UP UP - -

29 UP UP UP - UP

30 UP UP UP UP -

31 UP UP UP UP UP

SWITCH UP FOR "ON"

SWITCH DOWN FOR "OFF"

SHOWN SET FOR

HOUSE ID # 30

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 131 132

Comentários a estes Manuais

Sem comentários

ADEMCO Security System VISTA-15CN Guia de Configuração Página 37

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso ADEMCO Security System VISTA-15CN