ADEMCO Security System VISTA-15CN Guia de Configuração descarregar pdf (Página 91)

Section 17 - Output Device Programming

17–5

The second condition for turning on the indicator is triggering a

24-hour aux. zone (Zone Type 08). Therefore, program (ZT) as

. Press

[

✱

]

to continue.

To stop the Device action and turn off the lamp, you do not

want to use a restore of any zone, so enter a

for Stop: Zn Lst

(ZL). Press

[

✱]

to continue.

To stop the Device action and turn off the lamp, you do not

want to use a system operation or zone type, so enter a 0 for

Stop: Zn Typ. (ZT). Press

[

✱]

to continue.

NOTE:

A manual entry of

User Code + # + 8 + Device No

. (

in this example)

is used to turn the device off. Therefore, you do

not need to program a STOP event.

The system displays a summary screen for the START

programming for device 01. Press

[

✱]

to continue.

The system displays a summary screen for the STOP

programming for device 01. Press

[

✱]

to continue.

The system displays the X10

prompt. Enter

for yes.

The

ENTER DEVICE NO.

prompt for the next zone is

displayed.

Press

and then

[

✱]

to exit the

✱

80 mode.

Now use

✱

81 Zone List mode to program the 3 specific zones in Zone

List 01.

If you want to use zone type 12, 24-Hour Monitor, to activate a relay, all zones of that type must

be placed into a zone list and triggered by a “fault” event

. The same zone list must be

programmed for the “STOP” event. A restore of every faulted zone in that zone list is required to

deactivate the relay.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 131 132

Comentários a estes Manuais

Sem comentários

ADEMCO Security System VISTA-15CN Guia de Configuração Página 91

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso ADEMCO Security System VISTA-15CN