ADEMCO Security System VISTA-15CN Guia de Configuração descarregar pdf (Página 89)

Section 17 - Output Device Programming

17–3

If a relay is energized before a 4-wire smoke detector is reset, the relay is stopped by the

interruption of Aux.

Power that resets the smoke detector. If this is not desired, supply power to

the relay unit from another 12V power source (e.g., the same source that is powering external

equipment through the relay contacts).

Programming Output Relays and Powerline Carrier Devices

While in Program mode, press ✱

80 to enter Output Device Menu mode. This mode is used to

program all output devices used in the system 4204 or 4229 Relay Modules, or Powerline

Carrier devices). Refer to the Output Device Table for

✱

80 in the separate Programming

Form when programming Output Devices.

NOTE: If you are using Powerline Carrier devices, the House ID of the devices must be

entered in data field

✱27.

After you key in

✱80, the following prompts are displayed.

Output Device Displays

Enter Device No.

(00 = Quit) 01

Enter the Device Number

, or

for a 4204;

for a

4229;

–

for Powerline Carrier devices; or

to end these

entries. Press

[

✱]

to continue.

The

[

✱]

key is used to accept an entry and advance to the next

prompt. The [#] key is used to revert back to the last question to

check or change an entry. Press

[

✱]

to go forward again.

02 A EV ZL ZT -

STT 0 0 0 00 -

This screen displays a summary of the current Device START

programming (for this example, device 02 has been selected).

Press

[

✱]

to continue.

02 A EV ZL ZT -

STP – – 0 00 -

This screen displays a summary of the current Device STOP

programming.

Press

[

✱]

to continue.

02 Device Action

No Response 0

Enter the desired device action as listed below. Press

[

✱]

continue.

0 = No response 2 = Stay Closed

1 = Close for 2 seconds 3 = 1 second On/Off

02 Start Event

Not Used 0

Enter the event to START

the relay:

0 = Not used; 2 = Fault; 1 = Alarm; 3 = Trouble

A zone list must be used in conjunction with an event. If a zone

type/system operation is to be used instead of an event, enter

Press

[

✱]

to continue.

02 Start: Zn Lst

No List 0

If a zone list is used to START the relay action, enter the zone list

number (to be programmed in field

✱

81):

, or

. If not used,

enter

. Press

[

✱]

to continue.

02 Start: Zn Typ

Zone Disabled 00

If a zone type or system operation is used to START the device

action, enter the appropriate 2-digit code (see table that follows). If

not, enter

Press

[

✱]

to continue.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 131 132

Comentários a estes Manuais

Sem comentários

ADEMCO Security System VISTA-15CN Guia de Configuração Página 89

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso ADEMCO Security System VISTA-15CN