ADEMCO Security System VISTA-15CN Guia de Configuração descarregar pdf (Página 84)

VISTA-15/VISTA-15CN Installation and Setup Guide

16–8

2. Select from templates. Press [

✱

] to display template (1 shown

selected). NOTE: If necessary, press [#] to back up and re-enter

template number.

3. Press [#] if you want to return to zone attributes screen.

L 01 02 03 04

T 21 22 23 28

When you press [✱], the selected template is displayed.

Top line of display represents loop numbers, bottom line

represents zone type assigned for each zone.

5. Press [

✱] to accept template.

ENTER START ZONE

00 = QUIT 22

Example of zone

↑

suggested by

the

system. This indicates

that zones 22, 23, 24,

and 25 are available.

6. The system searchs for the highest zone number available,

subtracts the number of consecutive zones required for the

device (four zones in the case of the 5804 and 5804BD), and

displays the lowest zone number of the group.

If you want to start at a different zone, enter the zone desired

and press [

✱].

If that zone number is displayed, the system has the required

number of consecutive zones available, beginning with the zone

you entered. If not, the system again displays a suggested zone

that can be used.

If the required number of consecutive zones is not available at

all, the system displays “00”.

7. Press [

✱] to accept.

INPUT S/N L

AXXX-XXXX –

8. Enter the serial number of the wireless key or depress any

button to transmit from the wireless key.

9. Press [

✱] to accept the serial number. The system checks for a

duplicate number.

10. If necessary, press the [#] key to back up without saving, and

re-enter the serial number.

If you are manually entering the serial number, use the [A] key

to move forward within the screen, and the [B] key to move

backward.

XMIT TO CONFIRM

PRESS

✱

TO SKIP

11. If you entered “Yes” at the SET TO CONFIRM? prompt

previously (see first prompt following entry into the

✱58 Expert

Programming Mode on page 16-4), the display on the left

appears. Confirm serial and loop numbers by activating the

wireless key.

Keyd A022-4063 –

Rcvd A022-4064 3

If the serial number transmitted does not match the serial

number entered, a display similar to the one at left appears.

If it doesn't match, press any button on the transmitter once

again. If a match is not obtained, press the [#] key and then

enter the correct serial number (steps 8 through 10 above).

If the serial number transmitted matches the serial number

entered, the keypad beeps 3 times and returns you to step 6

above to enter the starting zone for the next wireless key.

NOTE: Following the successful enrollment of each wireless device, remove ONE of the serial

number labels from the device and affix it in the appropriate column on the ENROLLED

TRANSMITTERS worksheet of the Programming Form; then enter the other information (zone

number, zone type, loop number, etc.) relevant to that device. This information would be useful if

any troubleshooting is needed later on. The installer may want to consider leaving this

worksheet at the site (in the panel cabinet).

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 131 132

Comentários a estes Manuais

Sem comentários

ADEMCO Security System VISTA-15CN Guia de Configuração Página 84

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso ADEMCO Security System VISTA-15CN