ADEMCO 5130XM Manual de Instruções descarregar pdf (Página 41)

ZONE 1

STSTEbi CONFIGURATION (PERIPIH3bU.S~

4 1

- C. SMOKE DETECTOR CONFIGURATIONS -

When programmed as an EOLR supervised FIRE zone (type 09 in program

field ‘02) up to three O-wire smoke detectors can be used. Recommended

are the BRK1400 ionization detector, 2400 Photoelectric smoke detector,

and the 24OOTH Photoelectric smoke detector with 135°F heat sensor.

FOLLOW INSTRUCTIONS FOR INDIYIDUAL SMOKE DlTEClDRS FOR PROPER INSTAUATION

AND WIRING.

*USE BAK MODEL 1400.2400. OR 240Vt.H ONLYI

Diagram 20. ZONE 1 EOLR SUPERVISED FOR O-WIRE SMOKE DETECTORS

ADVISORY

If the EOLR is not at the end of the loop, the zone is not fully supervised. The

system will not respond to an open circuit within the zone.

ZONES 2 THROUGH 8

These zones can suppart as many 4-wire Smoke detectors

can be

powered, when programmed as a FIRE zone, type 09, in program field ‘02.

There

are

only two requirements: (1) The zones must be configured for

EOLR supervision, and (2) A normally-closed, momentary Switch must be

Installed in series with the power to the detectors in order to allow reset of the

smoke detectors after an alarm. The detectors must be wired in parallel, with

the EOLR at the last detector, for full supervision. as shown:

ANY ZONE.2THRUS

TB2

USE OF RELAY

SMOKE

DETECTORS

II II

lmo OHM

END OF LINE

RESISTOR

FOLLOW INSTRUCTIONS FOR INDIVIDUAL SUDKE DEMXDRS FOR PRDPER INSYALLATIDN AND WIRING

FDR CtRtXJll AND PDWER

D&gram 21. ZONES 2-8 EOLR SUPERVISED FOR CWIRE SMOKE DETECTORS

ADEMCO’s

VISTA XM SERIES TECIYNICAL REFERENCE

MANUAL

WWW.DIYALARMFORUM.COM

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 158 159

Sem comentários

ADEMCO 5130XM Manual de Instruções Página 41