ADEMCO 5130XM Manual de Instruções descarregar pdf (Página 97)

PROGRAMMING TXE SYSTEM

CREATING A

CUSTOM MESSAGE

Normally, when the sy6tem Is In the disarmed state, the following display is

present on the Console.

““DISARMED”” READY TO ARM

DISPLAY

Part or ail of the above message can be modlfied to create a custom in6taiier

(iNBTALLER’B MESSAGE) message. For example, ““DISARMED

*** on the first line or READY TO

ARM on the second line could be replaced by the installation company name

or phone number for service. Note that there are only 16 character spaces on

each of the two ilnes. To create a custom display message, proceed as

follows:

1. Enter the programming mode.

2. Key ‘93. The foiicwuing wiii be displayed:

l ZN

3. Key 00. The following will appear:

ED ?

4. Press the [S] key. The foliowing will appear:

““DISARMED-’

READY TO ARM

A cursor will be present at the extreme left of the first line (over the first

‘star”). The [S] key k used to move the cursor to the right and the [4] key

to move the cursor to the left. Key [7J may be used to to insert spaces or

era6e existing characters.

5. For example, to replace READY TO ARM with the message

SERVICE:424-0177, proceed as follows:

Press the (61 key to move the curSor to the right, and continue until the

cursor is positiined over the first location on the second line.

Press the [3] key to advance through the alphabet to the first desired

character (in this case, “S”). Use the [1] key to go backward, when

neccessary. When the desired character is reached, press [S]. The cur6or

will then move to the next position. ready for entry of the next character

(in this example, “c). When the cursor reaches a position over an

existing character, pressing the (31 or (11 key will advance or back up from

that character in the alphabet. Proceed in this manner until ail characters

in the message have been entered.

6. To store this new display message in memory, press the [S] key.

7. Press the n key to return to the

ZN ?? display. To confirm that the new

message.has been stored in memory, press 00 and then press key [5].

The new’message should be displayed.

8. Key l 99 to exit the descriptor/programming mode.

ADEMCO’s

VISTA

SERIES TECHNICAL REFERENCE MANUAL

WWW.DIYALARMFORUM.COM

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 158 159

Comentários a estes Manuais

Sem comentários

ADEMCO 5130XM Manual de Instruções Página 97

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso ADEMCO 5130XM