ADEMCO 5130XM Manual de Instruções descarregar pdf (Página 81)

PROGRAMMING THE SYSTEM 81

KEYSWITCH ARM/DISARM l 15

ENABLE

(O/l )

COMMENTS: Enter

for keyswitch enable: other&se, enter 0.

Requires the use of zone 7 wired bop (zone 7 no longer available as

protectiin zone when used for keyswltch operation).

NOTE: Zone type 10 nust have been entered for Zone 7 in field ‘02.

Reports opening&losing by user #7 ff reporting is enabled in field

‘52. lf this field is enabled (enter

l),

the fire and panic alan voltage

triggers automatically become ARMING and READY status outputs

for support of the Keyswltch LEDs.

MULTIPLE ALARMS

(O/l 1

‘23

COMMENTS: Enter 1 to enable the system to permit multiile audible

alarms from a protection zone during one armed interval (as opposed

to only one alarm). Enter 0 for only one alarm. Note that multiple

alarm soundings will not occur more frequently than allowed by the

alarm time-out). This selection has no impact on the number of

communication messages transmitted.

DISABLE 4190WH ‘24

TAMPER DETECTION IN

EXPANSION ZONES lo-64

COMMENTS: Only applicable if No. 4190WH RPMs are used to

TEST INTERVAL

(O/l/2/3)

TEST INITIATION TIME

(01-31)

POWER UP

PREVIOUS STATE

(O/l 1

provide expansion zones. Enter 1 to disable tamper detection.

Enter 0 to enable tamper detection (opening of the 4190WH case).

‘27

COMMENTS: Enter the test interval as follows:

Enter 0 for no report,

for every 12 hours. 2 for every 24 hours or 3 for every 166 hours (1

week). Must be used in conjunction with data fields

63 and ‘66

(location 5). This field enables the automatic battery test. At the

interval selected, AC power will be dropped and the battery will be

tested under auxiliary current load for about 10 minutes. It a test

report is desired, enter a test code in field ‘66. location 5..

COMMENTS: Enter the time in hours from the time that the

programming mode is exited that the first test report shall be

transmltted, and/or first battery test initiated. 00 entry signifies

immediately upon exiting.

- 31 represents the range in hours

that can be selected. See field ‘66 for assigning the Test Report

code.

‘26

COMMENTS: Ente?l if it is desired that upon power-up (after a low-

battery is sensed), the system will assume the system status prior to

power down. Enter 0 if it is desired that the system will atways power

up in a disarmed state. When the system powers up armed, an alarm

will occur 3 minutes after arming if a zone is faulted. When so armed,

reports closing as User #7 if open/close reporting for User #7 was

enabled in Address ‘52.

ADEMCO’s VISTA Xbf SERIES TECHNICAL REFERENCE MANUAL

WWW.DIYALARMFORUM.COM

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 158 159

Comentários a estes Manuais

Sem comentários

ADEMCO 5130XM Manual de Instruções Página 81

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso ADEMCO 5130XM