ADEMCO 5130XM Manual de Instruções descarregar pdf (Página 75)

PROGRAMbfING TRE SYSTEM

LIMPORTANT!: Pre-programmlng of the desired communlcetlon format

must be ’

performed before programming any other flelds. See step 3 of PROGRAMMING

STEPS paragraph for Instructions.

FACTORY DEFAULT VALUES ARE SHOWN NEXT TO THE BLANK PROGRAMMIND FIELB BOXES.

(NOTE THAT FlELOS 14, 20, 22, 66, 8fi, -106, 107, 114, lr5. 116, 117, 110 6 141 ARE NOT USED )

For a complete li8t of factory dofrult sottinge, in numrrlwl ardor, aoo

SUMMARY OF CONNECTIONS l oction.

- 8. SECURITY ACCESS CODES -

INSTALLER CODE

10-Q)

MASTER SECURtTY CODE

(0-Q)

OPEN/CLOSE REPORTING

ENABLE BY USER CODE

‘00

‘01

‘52

User:

‘39

User:

1’00

User:

BABYSITTER CODE 1’50

ENABLE (User 22)

(O/l I

COMMENTS: This bdigit code is resewed for installation company

use but can be used by the customer if needed. This is the only code

that can be used to enter the Program mode from the console. This

code cannot be used to enter secondary codes. This code is

disabled if programming mode is exited by a 38.

I 1 1 1 1

r lI21314[

COMMENTS: Enter the 4 digit master securtty code. Use of a 9 in

fast position inhibtts the Duress feature. This code can assign

secondary codes 03-22.

2 3 4 5 6.7 8

I 1 1 1 1 1 1 ’ 1

9 10 11

12 13 14

15 16

I 1.1 I

1 I 1

17 16 19

20 21 22

[ 1

I 01 01 Ol Ol Ol 01 01

1 01 Ol Ol 01

01 01 01 01

1 01 01 01 01 01 01

COMMENTS: Enter 1 for each user code which is to send

open/close reports to the central station. Note that user #7 must be

enabled if either (a) open/close reporting is desired for keyswitch

armfng or (b) close reporting is desired for ‘Quick Arm” and ‘Power

Up. arm, or (c) OpenlCtose reporting is desired for remote armWarm

via downloading.

Note that user codes 16-22 are sent as user #15 for traditional

communication formats. To receive all user codes, Adernco Contact

ID reporting must be used.

COMMENTS: Enter 1 if user 22 is to be prohiied from disarming

the system unless the system was previously armed by user 22.

Enter 0 if user 22 is to be permitted to arm and disarm the system,

regardless of which user previously armed the system.

ADEMCO’s VISTA XM SERIES TECHNICAL REFERENCE MANUAL

WWW.DIYALARMFORUM.COM

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 158 159

Comentários a estes Manuais

Sem comentários

ADEMCO 5130XM Manual de Instruções Página 75

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso ADEMCO 5130XM