ADEMCO 5130XM Manual de Instruções descarregar pdf (Página 48)

SYSTEM CONFIGVRATXON (PERIPRERALS)

.-.

- G. REMOTE KEYSWITCH OPERATION & WIRING -

ADVISORY

If the keyswftch option is selected (field ‘15) the alarm trigger outputs are

disabled.

An optional Remote Keyswttch, can be used for remote arming and disarming

of the system. If used, and programmed by the installer (‘15=1), a normally-

open momentary switch is connected across a 1000 Ohm resistor on zone 7

of the control panel (Zone 7 must be given up as a protection zone but must

still be assigned a zone type). A momentary short across this zone will arm the

system in the .AWAY’ mode. If the short is held for more than 3 seconds, the

system will arm in the -STAY mode. (All zones designated as zone types

10 will be automatically bypassed). After the system has been armed, the

next time zone 7 is shorted, the system will disarm.

An optional closed-circuit tamper switch (model 112) can be wired in series

with zone 7. so that, if the switchplate is removed from the wall, the tamper will

open, disabling keyswitch operation until the system is next disarmed from

the console.

NOTES:

1. When keyswitch is selected, a 1000 ohm resistor must be used

regardless of whether.or not zones 2-8 are selected to use end of line

resistors.

2. Only one keyswitch with LEDs can be supported by the system’s power

supply. If more than one keyswitch is to be used, a 688-12 switching

module must be used to boost the signals used to drive the LEDs.

LED indications are defined as follows:

.’ -.

DISARMED & READY

ARMED AWAY

:-.

Diagrem 300. KEYSWITCH WIRING

ADEMCO’r VISTA X&i SERIES TECHNICAL REFERENCE MANUAL

WWW.DIYALARMFORUM.COM

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 158 159

Sem comentários

ADEMCO 5130XM Manual de Instruções Página 48